Sets to an elastic-like state, ready for removal from the mouth in just one minute. The primary clinical advantage of this bis-acryl composite is its elastic behavior during polymerization. This memory will allow you to pull it from undercuts or non-parallel tooth preparations and return it to its original form.

• Removes from mouth in 60 seconds
• Low shrinkage, low heat, high compressive strength
• Enhanced color stability, less staining and radiopaque
• Seven popular VITA* shades, plus bleach shade
• 40% less waste due to smallest possible mixing tips
• MMA-free: no unpleasant taste or smell
• Can be easily repaired with flowable composite
• Compatibility with both eugenol and non-eugenol cements
• High polishability

Product Literature... Click Here

Compressive strength...............................200 Mpa
Transverse strength.....................................95 Mpa
Vickers hardness..................................................23
Linear polymerization shrinkage..................0.18%
* Not a trademark of Centrix, Inc.

Instructions for Use:

1) Just inject into pre-operative impression, insert into mouth and wait one minute.	2) Access Crown turns semi-elastic for easy removal.	3) Trim with composite instruments, repair with flowable composite.	4) The final self-cure set takes only 2.5 minutes more.

Access Temporary Cement is the perfect choice for short-term cementation of crowns and bridges.
The auto mix system eliminates pad mixing and delivers a perfect mix every time. And the small hand syringe eliminates the need for a bulky mixing gun. A softer, semi-elastic set allows for easier removal and minimal clean up. Access Temporary Cement has thick and semi-elastic properties for safe adhesion to a temporary crown or bridge. Flexible set for good retention and easy removal. Containing calcium hydroxide, Access Temporary Cement supports tooth vitality with the formation of secondary dentine and provides a bacteriostatic effect. Ideal for use with Access Crown, acrylic, implant retained crowns or other well-fitted prosthesis with no open margins. If you have open margins, this type of cement may “wash out”, causing sensitivity and failure. It contains calcium hydroxide as a bacteriostatic agent to inhibit mold growth. It flows easily, due to its low film thickness, making for easy placement. It is stable in the mouth, strong and flexible, allowing for easy removal.

Product Literature... Click Here

• Loads easily into restorations
• Bacteriostatic - contains calcium hydroxide
• Easy removal of excess cement due to two phase set
• Aesthetically pleasing shade match
• No eugenol to interfere with resin placements
• More patient comfort – removes cleanly before final cementation

The convenient take-home application provides your patient with a professional temporary cement that will reduce emergency visits and offers an immediate solution when traveling.
NoMIX Temporary Cement is a single-component, moisture activated, non-eugenol temporary, white cement designed for short-term cementation of crowns and bridges.

It may be used with crowns made of temporary or permanent materials (acrylic, composite, PFM, etc.). Extremely easy to use, dispense and clean up.

NoMIX Temporary Cement is supplied in 1ml syringes or .50gr unit dose, take-home applications.

The syringe allows dispensing directly into a provisional restoration without the need for a wasteful automix tip.

The new unit dose take-home application can also be directly dispensed for a single provisional restoration in or out of the office.

Product Literature... Click Here

• Single-component, moisture Activated,
  non-eugenol, temporary, white cement
• Expands slightly upon setting
• Low film thickness
• No mixing, no mess
• No wasteful mixing tip
• Easy to remove from prep

D/Sense Crystal is a one-step, dual-action desensitizer and cavity liner. It reacts with dentin to precipitate microcrystals of calcium oxalate and potassium nitrate. These crystals penetrate deeply into the tubules and seal the dentinal surface with a continuous, acid-resistant complex (typically less than 3 microns thick).

Product Literature... Click Here

• Patented single component, dual action formula
  • Provides fast desensitizing with deep, long lasting crystal formation
  • Occludes dentinal tubules with calcium oxalate and potassium nitrate
• Unique delivery system
  • Time-saving, single step technique, less waste – apply what is needed
• SofNeedle™ Applicator
  • Long lasting results – gentle on soft tissue

INDICATIONS FOR USE:

• Cervical erosions
• Under crowns and bridges, when a standard cement is used
• On any exposed dentin surface, such as the margins around temporary crowns
• Before and after tooth bleaching
• Under restorations
• Gingival recession
• Before and after prophy

All prices are MSRP (Manufacturer's Suggested Retail Price)